Coating machine

General introduction to Coating machine

　　The mineral powder surface coating machine--an outcome of the development of new and high technology-- is widely used in plastic, rubber and dope industries, it can well improve the powder compatibility, enhance binding force of interfaces, rise the mechanical strength and comprehensive ability and add special physical and chemical property.

Advantages of Coating machine

　　Advantages:

　　The process is mature and investment is low, which is suitable for coating modification of stearic acid. Self-friction heat generation, less accessory equipment;

　　It is suitable for the modification of 325 ~ 1250 mesh powder.

　　Disadvantages:

　　Low air volume, dispersion was weak, especially fine powder, with more modifier dosage;

　　Self-friction heat generation is easy to be affected by environmental factors, and hard to control the modification temperature ;

　　There is dead zone and low coating rate.

Working principle of Coating machine

　　Principle and characteristics: the relative motion of three rotors can change the effect of cyclone and eddy current to realize the coating of powder surface. Without heating device, it has the advantages of low investment and low operation cost.

　　Power range: 11kW ~ 225kW

　　Maximum capacity: 6t/h

Technical Data of Coating machine

Model	SG200	SG3/300	SG3/600	SG3/900
Size (D97:10μm)	150kg/h	1.5t/h	3t/h	6t/h
Power	11kW	55.5kW	111kW	225kW

　　Main specification

Model	Main Power (kw)	Blower Power (kw)	Speed of Shaft (r.p.m)	Capacity (kg/h)	Weight (t)	Overall Dimension (L*W*H)mm
CLG-200D	11	2.2	4600	40-150	1	3200*600*2200
CLG-3/300	3-18.5	5.5	4500	500-1800	3	5800*1800*5600
CLG-3/600	3-37	15-22	2700	2000-4000	10	11200*3100*6200
CLG-3/900	3-75	45	1800	4000-7000	20	21000*3800*6500
NOTE: Capacity is according to medium hard limestone.The size,humidity level and characters of materical swill influence the capacity.